From US $76 / 2000 PIECE (EXW)

K-Type Bottom-Mount Tile Cladding Clip

The K-Type Bottom-Mount Tile Cladding Clip is a bent K-type mechanical fixing clip designed for ceramic tiles, porcelain slabs and other thin cladding panels installed beneath a horizontal beam or crossbeam.

Like the standard K-Type Cladding Clip, it uses a figure-eight groove prepared in the rear of the panel. The two hooked sections engage with the groove to create a mechanical interlocking connection. The bent body of the clip then allows the fixing point to be positioned on the underside of the supporting beam.

Bottom-Mount Installation

After the figure-eight groove is prepared, the K-Type clip is inserted from the side of the panel and positioned at the required location. Once the panel is installed, the bent section of the clip is secured to the underside of the horizontal beam using an appropriate mechanical fastener.

The groove position is important for this installation method. The distance between the groove and the upper and lower edges of the panel must be accurately designed:

• Groove too close to the edge: the clip may interfere with or contact the beam.
• Groove too far from the edge: a gap may remain between the clip and the beam, affecting the intended fixing position.

For this reason, accurate groove positioning and fabrication are particularly important when using the Bottom-Mount K-Type Clip.

Typical Applications

This clip is mainly used for tile or porcelain panels installed beneath horizontal beams, crossbeams or similar overhead structures. Because horizontal beam applications are relatively limited, it is a more specialized K-Type fixing solution.

Key Features

Customized dimensions available

Bent K-Type mechanical fixing design

Figure-eight groove interlocking

Bottom-mount installation

Suitable for tile and porcelain panels

Designed for horizontal beam applications

Requires precise groove positioning